Description

Specifications\r\n\r\nHeight (BH): 13in (33cm)\r\nWidth (W): 15in (38cm)\r\nDepth (D): 11.5in (29cm)\r\nHandle Height (HH): 17in (43cm)\r\nWeight (empty): 8 lbs. (3.5kg)\r\nMax Payload: 35lbs (16kg)\r\nInternal Volume: 1100in3 (18L)\r\n\r\nCapacity\r\n\r\nVertical Tiered Tool Pockets: 36\r\nFlat Zippered Pockets: 4\r\nD-Rings: 2 large and 4 small\r\nStainless Steel Tape Clip: Yes\r\n\r\nBuild\r\n\r\nWaterproof Base: 3mm Injection Molded Polypropylene\r\nWaterproof Body Fabric: 1800 PVC Impregnated Denier Nylon\r\nWaterproof Tool Pocket Fabric: 1800 PVC Impregnated Denier Nylon\r\nHandle: Injection Molded Nylon Plastic w/ over-molded rubber grip\r\nZippers: Double Stitched, Heavy Duty Plastic Coil Zippers with Oversized Zipper Tabs\r\nFold-Back Snaps: 6 zinc, marine grade\r\nD-Rings: Powder Coated Steel\r\nRivets: 38 zinc, marine grade rivets\r\nStitching: Industrial Strength Double Nylon Stitching\r\n\r\nFeatures\r\n\r\nShoulder Strap: Heavy Duty, Non-Slip Padded Shoulder Strap\r\nWarranty: 5 Years (see Veto warranty terms and conditions)\r\n\r\nKeep the Zippers Clean and Lubricated\r\nOver time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.\r\nProtect the Zippers From Sharp Objects and/or Excessive HeatAny sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.\r\nDon’t Overstuff the BagOverstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!