Description

The MB3B is our largest meter bag with 14in of vertical storage space with capacity for 2-3 meters and tool storage. This bag works over-time to make service calls quick and efficient.\r\nSpecifications\r\n\r\nHeight (HH): 15in (38cm)\r\nWidth (W): 14in (35.5cm)\r\nDepth (D): 7in (18cm)\r\nWeight (empty): 4lbs (2kg)\r\nMax Payload: 35lbs (16kg)\r\nInternal Volume: 490in3 (8L)\r\n\r\nTablet Pocket Dimensions\r\n\r\nHeight: 10in\r\nWidth: 9.5in\r\n\r\nCapacity\r\n\r\nOne Large Storage Bay With Pull-Out Thermoformed Insert Box Offering Padding And Protection For Meters\r\n7 Outside Vertical Tool Pockets\r\n1 Large Front Velcro Flap Lead Pocket\r\n3 Webbed Attachment Points On Backside\r\nBackside Padded Tablet Pocket\r\n\r\nBuild\r\n\r\nYKK Zippers\r\nPolypropylene Plastic Base For Moisture And Abrasion Protection\r\nPadded Shoulder Strap\r\nWarranty: 5 Years (see Veto warranty terms and conditions)\r\n\r\nKeep the Zippers Clean and Lubricated\r\nOver time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.\r\nProtect the Zippers From Sharp Objects and/or Excessive Heat\r\nAny sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.\r\nDon’t Overstuff the Bag\r\nOverstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!